Oops Map sensor

SilverTrackSurfer

Paid Member
So had the clio a little gone a month now. Done the usual search the forum checked out the how to guides for any must do mods etc.

Found a thread about the wobbly map sensor so thought id give it a try sealing it up better. Looked at mine and yup wobbly as hell. So took the car for a run to get it warm to help pop the little bugger out, but yet the little bugger still snapped in the inlet!!! The worst bit is, its looking straight at me through the hole .

Im going to pop the upper inlet off tomorrow and get that little bastard out. Any tips on removing etc or straight forward like any other inlet?
 
sorry but i was lol..your description is well funny :sweatsmile:..anyway,sorry to hear..not done it myself but if you have a tool box..it should be pretty straight forward..undo the bolts,throttle body and woala...keep us posted..
 
So had the clio a little gone a month now. Done the usual search the forum checked out the how to guides for any must do mods etc.

Found a thread about the wobbly map sensor so thought id give it a try sealing it up better. Looked at mine and yup wobbly as hell. So took the car for a run to get it warm to help pop the little bugger out, but yet the little bugger still snapped in the inlet!!! The worst bit is, its looking straight at me through the hole .

Im going to pop the upper inlet off tomorrow and get that little bastard out. Any tips on removing etc or straight forward like any other inlet?
I,did it myself. Easy to remove. Just remember to tilt manifold so it doesn’t go into head
 
sorry but i was lol..your description is well funny :sweatsmile:..anyway,sorry to hear..not done it myself but if you have a tool box..it should be pretty straight forward..undo the bolts,throttle body and woala...keep us posted..
There was suppose to be some emjoi faces in there, they obviously failed too hahah.
 
Make sure you buy oem new one, the aftermarket are crap.
To be fair i have just cable tied and put some gasket sealant on it for now, as it was only the bit where the o ring snapped off. So hoping that will last me until next week when i get paid then i shall buy oem one. I know with previous stuff and when younger dont ever buy cheap especially sensors lol.

Well i got the little bugger out this morning. Very easy and straight forward to be honest. IMG-20171115-WA0000.jpeg 20171115_114838.jpg
 

Attachments

  • 20171115_114838.jpg
    20171115_114838.jpg
    1.7 MB · Views: 12
this works every time till the ecu adjusts..it never goes back to what it was though..still an improvement :thumb:
 

Similar Thread Suggestions