Recent content by ZackyGec

  1. Z

    Clio 200 replacements?

    Looking for a turbo car. Something I can chuck around a corner. Budget is around £15k. Must have a nice interior. Not a megane. Prefer a DSG gearbox. Any ideas guys?
  2. Z

    Check Injection then Injection Fault then Limp mode

    I do have one yes. I will have a look when I get in as I was getting the P0225 error. Thanks
  3. Z

    Check Injection then Injection Fault then Limp mode

    Hi there, I have a 200. Was sat in traffic and the check Injection light came on. Then went to put my foot down and it came up with Injection Fault. Now every time I start it, does the same and goes into limp mode. Anyone got any clue what's happening? I've plugged it in and nothing seems to...
  4. Z

    Best rapid detailer, insect remover and drying cloth?

    Mill get 2 of these and find out Thankyou!
  5. Z

    Best rapid detailer, insect remover and drying cloth?

    I have tried that rainex and loved it until I tried to use my windscreen wipers and it kept screeching....
  6. Z

    Best rapid detailer, insect remover and drying cloth?

    As above. Have a black 200 which makes it impossible to clean and dry ): so what's the best? Thanks
  7. Z

    Megane conversion. Basic in what I need?

    Okay so I've heard I need a custom wiring loom, customer engine mounts to do a Megane conversion. 1st question is where do I get them from? 2. What else do I need and roughly what cost am I looking at? thanks :D
  8. Z

    Best snow foam and best wheel cleaner?

    As above. What snow foam do you guys use and wheel cleaner on diamond cut alloys? thanks!
  9. Z

    Fitting Citroen washer jets.

    The two wide clips or the smaller ones?
  10. Z

    Fitting Citroen washer jets.

    Does anyone know how to fit Citroen washer jets? They fit in but at a right angle to where they should be so does anyone know how to fix them onto a 200? cheers
  11. Z

    Gearbox power flex mount... How do I fit?

    And do do you support the gearbox with a jack or not?
  12. Z

    Gearbox power flex mount... How do I fit?

    Give the steel plate? Or just the rubber section?
  13. Z

    Gearbox power flex mount... How do I fit?

    So I took out the battery gray, induction kit etc and there were 3 bolts holding the gearbox mount in. I undid the 2 either side and then the middle one and tried to get it out. There was no movement... Anyone got any ideas on how to fit this or what I'm doing wrong?
  14. Z

    Resistor after fitting a bucket seat.

    Anyone know what and how many resistors to fit after fitting a bucket seat. They're up and running but the Internet has given me such a range of answers. Cheers in advance.
  15. Z

    How do I make my bucket seats higher?

    Clio 200, today fitted 2 sparco seats however found out I can barely see over the steering wheel. What do people use to make them higher? cheers.