Search results

I need to remove and replace the A Pillar windscreen trims. Not ordered replacements yet so not sure if just need the plastic that reattach the rubber seals to or whether comes all together...trim and seals. Picture attached. Anyway any suggestions on removal before I start pulling away at...

Bit of a random question I know but what are the diameter of the standard Mk3 200 exhausts pipes...not the main system just the exit tips. I have a single Oreca race system that will be up for sale soon as going to try one of Pure Motorsports straight through systems. On the Mk3 200 diffuser...

Got a 200 track car which is stripped, caged etc. Getting round to some jobs been putting off for ages one of which is removing some of the redundant wires in the wiring loom - airbags, rear boot release etc etc. Don't even think ABS works any more on my car (might have removed control unit at...

Had a Flacsi carbon roof scoop fitted to my track car for ages and just wondered if anybody had ever come up with a good solution to the dripping when it rains. The water ingress isn't because I haven't sealed it properly to the roof but rain being driven in to the scoop when on track. Closing...

I've got a Clio 200 track car which I haven't used for a couple of years. There are a few jobs that I am getting back on to that I have left for a while (hence why a few of you might see a number of questions from me over the next few weeks). All airbags have been removed (basically the car is...

I've got a Clio 200 track car (stripped, caged etc) and have a towing eye and strap on the front of the car. I know the cup cars have the same on the rear and just wondered if anybody knew if there is the same threaded hole on the road cars behind the bumper and I would just need to cut a slit...

Have a Mk3 200 track car and looking to fit AST 5100's which also gives me the chance to fit custom springs rather than the standard springs they come with...I obviously don't need to worry about the compromise of it still being comfy for the road. I need to decide on what spring rates to go...

Just checking - is the screw arrowed the air bleed for the thermostat?

I am going to be removing the whole heater/air distribution unit soon from my 200 track car. Just wondered - does the unit have its own heater running its own water that it heats or does it use hot water from the coolant system. Just asking so I know when I am disconnecting it all will I lose a...

I posted this in the interior section and got very little response...I know that might mean nobody knows the answer but thought I would try and stick it on general. I have a 200 track car which is pretty much fully stripped now. I have already removed some wiring and am now trying to finish...

I have a 200 track car which is pretty much fully stripped now. I have already removed some wiring and am now trying to finish the job. Just wondered if anybody knows what the cables/wires are that are running in to the rear wheel arches. The attached pictures are from inside the boot and it...

I have a 2012 Clio 200. Gearbox was replaced under warranty when second gear crunched. Car now out of warranty and gearbox making a strange noise when barely under load (so when just gentle throttle cruising at say 60mph). Gear change is fine so could be bearings or something to do with preload...

Anybody know if CM Composites are still going? Chris has been making a part for me but I can't raise him and the website seems suspended. Cheers, Ian.

Just wondered if anybody had ordered wing mirrors for Clio Mk3 from MC Racing and if so what you thought about quality and fit/install. Link is below...

I've being trying to find a recentish post. It was a link to a french (I think) website that does carbon parts for various cars including Mk3 Clio. They did a carbon centre console without the radio slot which is what i am after. Anybody help me find it. Thanks, Ian.

Anybody fitted K-Tec's full manifold to a 197/200 and if so thoughts?

Could somebody recommend adjustable front suspension top mounts for my 2012 Clio 200. I want quality as it is a track car.

I have been slowly converting my 200 to a full on track car. I am going to change the springs and dampers (it's currently just running on H&R springs with original cup chassis dampers) but I'm not too bothered about having coilovers with lots of adjustment as I want to rock up at track days and...

Speed Management Unit I am finishing off stripping out my Clio 200. In front of the gear lever under the plastic trim is a small box that is the speed management unit. I have removed it and the car seems to still run ok apart from ESP warning. Does anybody know what this ECU exactly controls...

Interested in hearing from anybody who has had the K Tec camshaft upgrade on a Mk3 Clio 200. Do you notice the difference, any reliability issues etc? No replies please telling me I should spend the money on forced induction etc - I like the revvy racer feel. thanks