CM200
Paid Member
Hey all!
Back again ;D
Was thinking of cleaning the throttle body today and was wondering if I could take the upper inlet off at the same time to give it a good clean as well.
However, I read on one post about having to fiddle with the pulleys if you’re doing this? Will I need a new gasket or is it fine to simply remove and then put back on? Not super technical in the engine department
Literally just want to clean it down, give it a scrub to remove a bit of corrosion/oxidation etc etc.
Once again thank you all for your time and knowledge <3
Back again ;D
Was thinking of cleaning the throttle body today and was wondering if I could take the upper inlet off at the same time to give it a good clean as well.
However, I read on one post about having to fiddle with the pulleys if you’re doing this? Will I need a new gasket or is it fine to simply remove and then put back on? Not super technical in the engine department
Literally just want to clean it down, give it a scrub to remove a bit of corrosion/oxidation etc etc.
Once again thank you all for your time and knowledge <3