Quick question on power, my car has the below spec:
Catcam 402s
Y-pipe pre cat delete,
Main cat delete,
Ktec cat baclk system
ITG Maxogen
Recently fitted Renparts engine on 29K with compression check completed and ran 180 on all 4.
After a remap at ktec the car made 199.4bhp and 170lb of torque.
The induction kit was completely blocked at the point of mapping which I was not aware of, and I have since cleaned this out.
The car feels a lot more alive and you can really feel the power change as the cams kicks in, but are these numbers disappointing as I have seen cars with no mods and a map making between 197 and 201?
I need to get back on the dyno but would the blocked induction kit hold back a lot of numbers (meaning between 5-10bhp) or would that not make much difference?
Car was mapped at ktec and everyone is saying their rollers are very high and I am not seeing the effects of that. I am not chasing numbers but just expected a better result.
Catcam 402s
Y-pipe pre cat delete,
Main cat delete,
Ktec cat baclk system
ITG Maxogen
Recently fitted Renparts engine on 29K with compression check completed and ran 180 on all 4.
After a remap at ktec the car made 199.4bhp and 170lb of torque.
The induction kit was completely blocked at the point of mapping which I was not aware of, and I have since cleaned this out.
The car feels a lot more alive and you can really feel the power change as the cams kicks in, but are these numbers disappointing as I have seen cars with no mods and a map making between 197 and 201?
I need to get back on the dyno but would the blocked induction kit hold back a lot of numbers (meaning between 5-10bhp) or would that not make much difference?
Car was mapped at ktec and everyone is saying their rollers are very high and I am not seeing the effects of that. I am not chasing numbers but just expected a better result.